CHAPTER 7: MODBUS COMMUNICATIONS MODBUS MEMORY MAP
PQM POWER QUALITY METER – INSTRUCTION MANUAL 7–59
SWITCH C
continued
10DA Switch C Function 0 to 14 1 --- F20 0=NOT USED
10DB Switch C Activation 0 to 1 1 --- F27 1=CLOSED
10DC Switch C Time Delay 0 to 6000 1 0.1 x s F1 0.0 s
10DD Reserved
10DE Reserved
10DF Reserved
SWITCH D
10E0 Switch D Name characters 1 and 2 --- --- ASCII F10 ““
10E1 Switch D Name characters 3 and 4 --- --- ASCII F10 “ S”
10E2 Switch D Name characters 5 and 6 --- --- ASCII F10 “WI”
10E3 Switch D Name characters 7 and 8 --- --- ASCII F10 “TC”
10E4 Switch D Name characters 9 and 10 --- --- ASCII F10 “H “
10E5 Switch D Name characters 11 and 12 --- --- ASCII F10 “IN“
10E6 Switch D Name characters 13 and 14 --- --- ASCII F10 “PU”
10E7 Switch D Name characters 15 and 16 --- --- ASCII F10 “T ”
10E8 Switch D Name characters 17 and 18 --- --- ASCII F10 “D “
10E9 Switch D Name characters 19 and 20 --- --- ASCII F10 ““
10EA Switch D Function 0 to 14 1 --- F20 0=NOT USED
10EB Switch D Activation 0 to 1 1 --- F27 1=CLOSED
10EC Switch D Time Delay 0 to 6000 1 0.1 x s F1 0.0 s
10ED Reserved
10EE Reserved
10EF Reserved
Table 7–10: PQM Memory Map (Sheet 43 of 55)
GROUP ADDR
(HEX)
DESCRIPTION RANGE STEP
VALUE
UNITS and
SCALE
FORMAT FACTORY
DEFAULT
Notes:* Data type depends on the Command Operation Code.** Any valid Actual Values or Setpoints address.
*** Maximum Setpoint value represents “OFF”.**** Minimum Setpoint value represents “OFF”.
***** Maximum Setpoint value represents “UNLIMITED”.****** Applicable to older revisions with VFD display only
Courtesy of NationalSwitchgear.com
To Next Page
Loading...
