GE PT7800DH2BB - Tools Needed

– 12 –
Tools Needed
*To enable service of the upper
oven without removing the
complete wall oven from the
installation.
• Phillips head screwdriver or bit
• 1/4” hex head nut driver or socket
• 3/8” socket wrench
• 7 mm socket or wrench
• T10 Torx bit
• T20 Torx bit
• Upper oven door removal tool. WB01X10364 included with replacement door assembly.
Special Tools
No special tools are required to service these units. Upper oven screws are primarily Phillips head, and lower
oven screws are 1/4 in. hex head or T20. The screw mounting the fad board on the lower oven is a T10, and
the LH threaded nut on the convection blade is 3/8 inches.
• Service Harness Extension Part #: WX05X24267
$WRROWRDVVLVWWKHXQODWFKLQJRIDORFNHGGRRUFRXOGEHPDGHXSIURPDSLHFHRIVWLȺZLUHDPHWDOFRDW
hanger, or a piece of brazing solder. Be sure to cover with tape to prevent scratching of the door or trim.