GE S2020 - Page 207

Chapter 7 – Configuration
GE Reason Switches
REASON SWITCHES-TM-EN-3
207
Values must be inserted in
decimal format;
 Range: indicates that only
a range of specified UDP
ports will be used at this
QCE. Values must be
inserted in decimal
format.
 Dport: indicates which
destination UDP ports will be
used at this QCE. Possible
configuration is as follows:
 Any: indicates that all
incoming frames will be
used at this QCE;
 Specific: indicates that
only specified UDP port
will be used at this QCE.
Values must be inserted in
decimal format;
 Range: indicates that only
a range of specified UDP
ports will be used at this
QCE. Values must be
inserted in decimal
format.
o TCP: indicates that only TCP will be used
at this QCE, that is, this entry will map
frames based in many parameters
including if it is a TCP protocol. When
selected, the TCP Parameters will be
displayed. Possible configuration is as
follows:
 Sport: indicates which source
TCP ports will be used at this
QCE. Possible configuration is
as follows:
 Any: indicates that all
incoming frames will be
used at this QCE;
 Specific: indicates that
only specified TCP port will
be used at this QCE.
Values must be inserted in
decimal format;
 Range: indicates that only
a range of specified TCP