o Port number;
This number is a link which redirects to the Detailed
Statistics menu, explained at the Detailed Statistics menu.
o Packets: Received and transmitted traffic, in number of packets;
o Bytes: Received and transmitted traffic, in bytes;
o Error: Received packets containing errors and transmitted packets
incomplete;
o Drops: Received packets that were discarded based on ingress
congestion and transmitted packets that were discarded based on
egress congestion.
o Filtered: Received frames filtered by forwarding process.
QoS Statistics:
QoS Statistics option presents basic information about QoS being executed in each
port, as described below:
o Port identifier;
o Queues (Q0 to Q7 queues): Received (RX) and transmitted (TX)
frames at the queue;
QCL Status:
QCL Status option allows user to view information about the QoS Control List (QCL)
configured in the switch. A table containing the following information is shown:
o User;
o QCE identifier;
o Ports member of the QCL;
o Frame type configured at QCL;
o Action executed by this QCL when incoming frames match the QCL
filter. At the action columns, information about the CoS, DPL and
DSCP values are displayed;
o Conflict information, that is, if there was conflict in the QCE at the
QCL shown.
Detailed Statistics:
Detailed Statistics option allows user to view detailed traffic information for a given
Port. It is possible to access this menu by clicking in the Port Number at the Traffic
Overview menu.
To Next Page
Loading...
Need help?
General
