Revision A Transport Pro 2-13
2012659-042
Equipment Overview: Optional Component
TRAM Module
The monitor uses one TRAM module installed in the TRAM chute to
acquire patient data. The following TRAM modules are compatible, if
running software version 9B or later.
TRAM Communication Cable
The TRAM communication cable provides a communication and power
pathway between the TRAM module and the monitor.
Optional Component
Cadex SMart Two+ External Battery Charger
The external battery charger can hold and charge up to two batteries.
When you select the Target Capacity switch on the charger, the
charger compares the battery’s performance to a 60, 70 or 80 percent of
the target capacity set on the battery charger. If the battery fails to meet
the target performance, the battery charger will prompt you to condition
the battery. If the battery does not hold a charge, then the battery
charger will illuminate a “fail” light.
Module Part Number
TRAM 100 401174-0 _ _
TRAM 200A SL T200= _
TRAM 250 A SL T250= _
TRAM 350A 416646-001
TRAM 400A SL T400= _
TRAM 450A SL T450= _
TRAM 451 2006171-001
TRAM 451N 2006171-002
TRAM 451M 2006171-003
TRAM 500 402593-0 _ _
TRAM 600 A SL T600= _
TRAM 650 A SL T650= _
TRAM 800 A SL T800SL= _
TRAM 850 T850= _
TRAM 850 A SL T850SL= _
TRAM 851 2006171-004
TRAM 851N 2006171-005
TRAM 851M 2006171-006
To Next Page
Loading...
