GE Transport Pro - Eport Flex Circuit

Revision A Transport Pro 8-15
2012659-042
Disassembly: FRU Replacement
ePort Flex Circuit
1. Remove the back plastic. See “Back Plastic Disassembly” on page 8-4.
2. Remove the two screws that connect the flex circuit cable to the main
processor PCB shield.
3. Remove the battery housing. See “Main Processor PCB
Subassembly” on page 8-9.
4. Remove the two screws attaching the flex circuit cable to the back
plastic.
5. Replace the flex circuit.
6. Assemble the back plastic. See “Back Plastic Assembly” on page 8-6.
628A