GE Transport Pro - Alarm Light

8-14 Transport Pro Revision A
2012659-042
Disassembly: FRU Replacement
9. Assemble the back plastic. See “Back Plastic Assembly” on page 8-6.
Alarm Light
1. Remove the back plastic. See “Back Plastic Disassembly” on page 8-4.
2. Remove the display subassembly. See “Display Subassembly” on
page 8-7.
3. Disconnect the alarm light cable harness from the alarm light PCB
and the main processor PCB.
4. Replace the alarm light PCB and alarm light harness.
5. Connect the alarm light cable harness to the alarm light PCB and
main processor PCB.
6. Assemble the back plastic. See “Back Plastic Assembly” on page 8-6.
625A