Chapter 6. Logging Data
106 TransPort
®
PT900 User’s Manual
6.3.2 Editing a Log
To EDIT a Pending log, complete the following steps:
1. On the
LOGS main menu (see Figure 100 on page 104), click in the
SELECT column to the right of the log you wish to edit.
2. Verify that the icon is shown to the right of the log you wish to stop.
3. Click the
EDIT button to open the EDIT LOG menu shown in Figure 101
below.
Figure 101: The EDIT LOG Menu
4. Edit any of the log parameters in the above menu using the same
instructions given in “Adding a Log” on page 102.
5. After your edits are complete, click
UPDATE button to save your changes.
To Next Page
Loading...
