Chapter 4. Programming
70 TransPort
®
PT900 User’s Manual
4.5.3 Programming the Meter Factor
To program the METER FACTOR, refer to Figure 75 on page 66 and complete the
following steps:
1. Click on the
METER FACTOR button to open the menu shown in Figure 77
below.
Figure 77: The Calibrate Factor Menu
2. The
CALIBRATE FACTOR is used to calibrate or adjust the flow rate
readings of the PT900 to correspond with another flow rate reference. Use
the slide switch to set it to
On or Off, as desired.
To Next Page
Loading...
