GE TransPort PT900 - Programming the FLUID Menu

Chapter 4. Programming
64 TransPort
®
PT900 User’s Manual
4.4 Programming the FLUID Menu
The FLUID menu allows the user to specify all the parameters of the fluid flowing
through the pipe that are required to ensure accurate ultrasonic flow rate
measurements. An example of this menu is shown in Figure 74 below. See the
following sub-sections for the options available in programming the various fluid
parameters.
Note: The measurement units used for all fluid parameters in these menus
depend on the choices made in the
UNITS OF MEASUREMENT menu.
Figure 74: The FLUID Menu