GE TransPort PT900 - Programming the OUTPUTS Tab

Chapter 4. Programming
82 TransPort
®
PT900 User’s Manual
4.7.2 Programming the INPUTS Tab (cont.)
3. If General Purpose is chosen in the FUNCTION box, enter the correct
ZERO and SPAN values in the appropriate boxes.
Program
ANALOG INPUTS B using the same steps described for ANALOG INPUTS A.
4.7.3 Programming the OUTPUTS Tab
The OUTPUTS tab (see Figure 87 below) enables the user to specify the ANALOG
OUTPUTS
, DIGITAL OUTPUTS and MODBUS parameters.
Figure 87: The Outputs Menu