Chapter 4. Programming
TransPort
®
PT900 User’s Manual 77
4.7 Configuring the Program Options
Note: The programming instructions in this section are only required if you will
be using any of the options listed below.
From the
APP side menu, click the Program Options sub-menu under the
PROGRAM menu, as highlighted in Figure 84 below. This will open the Program
Options
menu shown in Figure 85 on page 78.
The
Program Options menu includes the following tabs:
• ENERGY (see page 79)
• INPUTS (see page 81)
• OUTPUTS (see page 82)
• USER FUNCTIONS (see page 87)
Proceed to the appropriate section for programming instructions.
Figure 84: The PROGRAM Menu
To Next Page
Loading...
