GE TransPort PT900 - Installing the Transmitter Battery Pack

Chapter 2. Installation
6 TransPort
®
PT900 User’s Manual
2.3 Installing a Battery Pack in the Transmitter
To install a new battery pack in the transmitter (see Figure 3 below):
1. Using a slotted screwdriver, rotate the two quick-screws on the battery
cover 90° to open the transmitter.
2. Remove the existing battery pack.
3. Install the new battery pack in the battery compartment and replace the
battery cover. Secure the cover by tightening the two quick-screws.
Figure 3: Installing the Battery Pack in the Transmitter
Cover
Battery Pack
Screws