Chapter 8. Error Codes and Troubleshooting
140 TransPort
®
PT900 User’s Manual
8.6 The Quick-Start Guide
The Quick Start Guide, which can be found on your SD card, provides general
instructions on using the flow meter and the APP. Start by watching the installation
videos on GE web site at
www.gemeasurement.com/pt900, and then complete the
following steps:
1. Check the PT900 transmitter and the tablet before use.
2. Load the APP onto tablet from either the SD card or from our web site (see
the link above).
3. Turn on the transmitter by holding down the power button for more than
two seconds. The green power
LED indicates that the power is On.
4. Open the PT900 APP on the
Tablet.
5. Connect the APP to the transmitter via Bluetooth communication.
6. Select the desired
Measurement Units option and program the meter with
correct pipe, fluid, transducer and placement information.
7. Install the transducers onto the pipe with the
Spacing information
calculated by the APP.
8. Set the tablet display to the desired values and to view the flow rate.
9. Continue with other operations, as described elsewhere in this manual.
To Next Page
Loading...
