D
IRECTION 5813707-100, REVISION 2 VENUE™ SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-9
PRELIMINARY
3) Gently pull the board upwards to remove it.
4.) Make sure you pull the C-PSB up vertically to avoid damaging the two connectors located on the
top side of the C-FEB.
8-2-4-5 C-PSB Installation Procedure
1) Fold the C-PSB magnetic absorber (MAGRAM) cover to allow easy insertion behind the black
rubber bumpers.
2.) Align the C-PSB module and screws over the screw holes on the C-FEB and connect the C-PSB to
the C-FEB connectors buy applying vertical pressure to the top side of the module.
3.) Tighten the four holding screws.
4.) Install back cover.
Figure 8-79 C-FEB Connectors
Figure 8-80 Magram support bumpers
• Back Cover Installation Procedure
To Next Page
Loading...
