GE DRAFT VOLUSON™ P8 / VOLUSON™ P6
DIRECTION 5723243, R
EVISION 6 DRAFT (MAY 23, 2018) BASIC SERVICE MANUAL
Chapter 5 - Components and Functions (Theory) 5-73
Please wait until the final window (Figure 5-47 below) appears and then press ENTER.
6.) Remove the System DVD from the DVD/CD+R/RW Drive.
7.) In the displayed menus select [Exit] -> [Exit/Reboot].
8.) During startup, press the DEL
key immediately, to enter the BIOS Setup.
9.) Using the “Arrow” keys [<-] or [->] on the alphanumeric keyboard select the [Save&Exit]tab.
10.)Select Load GE BIOS Setting xxxx (“xxxx” is the installed BIOS version) and then press Enter.
This changes the “Boot Priority” order back to 1.Boot:Hard Disk.
11.)Press the F10 key on the alphanumeric keyboard to save configuration changes
12.)Confirm the message with Yes and then press Enter.
NOTE: The system boots with windows. An automated process was developed to check disk, assign an unigue
computer name and matching drive letters. The system will reboot at least 2 times!
Figure 5-47 New Harddisk setup OK
Figure 5-48 Exit -> Exit/Reboot
To Next Page
Loading...
