– 31 –
7. Remove the 2 Phillips head screws that hold
the drain pump to the mounting plate. Remove
the drain pump.
5. Remove the 2 Phillips head screws that hold
the drain pump mounting plate to the washer
floor.
Disconnect
6. Disconnect the drain pump wires.
4. Remove the drain hoses from the pump:
Note: The drain hoses are difficult to remove due
to a sealing compound used at the factory.
a. Squeeze each clamp and slide it back.
b. Carefully break the hose loose by inserting
a small flat-blade screwdriver under the
hose to break the seal.
c. Remove the hose.
Caution: Care must to taken when reinstalling
and sealing the drain hoses to the outer tub to
ensure there is no water leakage.
When installing, apply a thin coat of sealing
compound (part no. WH60X15) to the inner
surface of the drain hoses.
Clamp
Clamp
To Next Page
Loading...
