– 46 –
LCD Display
Touchscreen
No error displayed. Unit will continue to
operate normally.
Screen will display
!
"# # #$%%&' %%( &)
% * &%+
Control sensed an LCD
display touchscreen input for
longer than 30 seconds.
1.) Wiring connections
or
2.) LCD display touchscreen
Lid Switch
Stuck Closed
Screen will display
& # )
and if opening is detected, the screen will
display
% # )
Operation
will stop until the washer detects the lid
has been opened.
Screen will display
!
"# # ) "#%' %%( &)
% * &%+
An attempt has been made to
start a cycle after 3 or more
consecutive cycles without the
washer detecting the lid has
been opened.
1.) Wiring connections
or
2.) Lid switch
or
3.) Inverter board
Lid Switch
Stuck Open
Screen will display
% # )
Operation will stop until the washer
detects the lid has been closed.
Screen will display
!
"# # ) "#%' %%( &)
% * &%+
The washer did not detect the
lid was closed within 5 minutes
of displaying "Please close the
lid"
1.) Wiring connections
or
2.) Lid switch
or
3.) Inverter board
Motor not
rotating
properly
Screen will display
#% !
& )#%#) "# # $&#
The
washer will stop operation.
Screen will display
!# & &#
##&, +' %( &) % *
&%+
Low voltage at main plug
or
Hall sensor indicates the
motor is not turning within
50% of the desired speed
or
Motor rotating in only one
direction
or
Basket not reaching desired
speed
or
Hall sensor indicates the
motor is turning 20% faster
than the desired speed
1) House supply voltage
or
2.) Wiring connections
or
3.) Motor
or
4.) Hall sensor
or
5.) Inverter board
Clutch
Screen will display
#% !
& )#%#) "# # $&#
The
washer will stop operation.
Screen will display
% $#% &#
!%&% + &,,&, "# # (#
+
The home position signal from
the clutch motor has not been
detected after three complete
revolutions of the clutch motor.
1.) Wiring connections
or
2.) Clutch motor
or
3.) Inverter board
To Next Page
Loading...
Need help?
General