8 Function introduction
8.1 Power loss-resuming capability
A20M has the power loss-resuming capability. When power recovery starts, it will pop up a
dialog to ask if continuing the unfinished print caused by power outage, choose “Resume print”.
See picture (8-1).
(Picture 8-1)
When it reaches the target temperature, the X and Y axes will auto home. The extruder will
extrude the residue in the nozzle. Use a tweezers to clean the nozzle before starting printing
again.
Note:
When power outage, move the nozzle away from the printing model in case the filament
oozes out on to the print.
Be sure to clean the residue in the nozzle before restarting the print or it would affect the
quality of the print.
8.2 Reset button
The reset button is below the knob. When the printer works abnormally, press the reset button
to reset the printer to avoid any damage. See picture (8-2).
(Picture 8-2)
To Next Page
Loading...
