8.3 Filament run-out sensor (Optional)
Before using this function, please check whether it is turned on or not. Choose
“Control”>”Filament”>“Runout sensors” and make sure it shows “ON”. See pictures (8-3, 8-4).
(Picture 8-3)
(Picture 8-4)
It will pop up the notification “Err: No Filament” when the filament is run out during printing
and the printer will stop. See picture (8-5).
(Picture 8-5)
Press the extruder handle, remove the remaining filament before loading the new filament.
When the filament is loaded, use a tweezers to clean the nozzle. Press the knob to enter the
main menu, and choose “Resume print” to re-start the printing. See picture (8-6).
To Next Page
Loading...
