44
SHENZHEN GETECH TECHNOLOGY CO., LTD
(Picture 8-31)
Note:
The printer can only read gcode file and the file name should be English letters, a space,
an underscore or their combination.
The Gcode file cannot be placed in any folder of the TF card, otherwise it cannot be read.
9 Color Mixer
9.1 Download
Download address: http://www.geeetech.com/forum/viewtopic.php?f=92&t=61760
9.2 Introduction
Color Mixer enables multicolor models to be printed by adjusting the extruder discharge ratio to
the original single-color model. The specific steps are as follows:
Click “Import G” to import .Gco file. Choose 3 as the “Extruder Number”. See picture (9-1
and 9-2)
To Next Page
Loading...
