49
SHENZHEN GETECH TECHNOLOGY CO., LTD
10 Function introduction
10.1 Power loss-resuming capability
A20T has the power loss-resuming capability. When power recovery starts, it will pop up a dialog
to ask if continuing the unfinished print caused by power outage, choose “Resume print”. See
picture (10-1).
(Picture 10-1)
When it reaches the target temperature, the X and Y axes will auto home. The extruder will
extrude the residue in the nozzle. Use a tweezers to clean the nozzle before starting printing
again.
Note:
When power outage, move the nozzle away from the printing model in case the filament
oozes out on to the print.
Be sure to clean the residue in the nozzle before restarting the print or it would affect the
quality of the print.
10.2 Reset button
The reset button is below the knob. When the printer works abnormally, press the reset button
to reset the printer to avoid any damage. See picture (10-2).
(Picture 10-2)
To Next Page
Loading...
Need help?
General
