Shenzhen Getech Technology Co.,Ltd
15
easier to insert filament into feeder. Press down the lever handle of the extruder and insert the
filament into the feeding tube until it reaches extruder head. Extruder E0, E1, E2 with arrow
shown in picture (5-16).
（Picture 5-16）
Please set the target temperature of nozzle about 190-210℃ when printing PLA. Control the
extruder feeding on touch screen after the nozzle temperature is stable. See picture
(5-17),(5-18).The extruder will feed automatically until the nozzle material is flowing. Please
select extruder E0, E1, E2 in turn.
（Picture 5-17）
To Next Page
Loading...
