Shenzhen Getech Technology Co.,Ltd
14
5.3Check the power input mode
The factory default voltage is 230V, please choose the correct voltage according to your local
voltage standard. See picture (5-14).
Note: Be sure the switch is set for the correct voltage.
（Picture 5-14）
5.4Load the filament
Put filament on spool holder, please pay attention to the feeding direction of the filament. See
picture (5-15).
（Picture 5-15）
Filament is bent, therefore it needs to be straightened by your hands and trimmed to make it
To Next Page
Loading...
