Shenzhen Getech Technology Co.,Ltd
55
（Picture 10-5）
1) It will pop up the notification “Err: No Filament” when the filament is run out during
printing and the printer will stop. See picture (10-6).
（Picture 10-6）
And at picture (10-7), if the “Filament “shows red, which indicates “No Filament”.
（Picture 10-7）
2) Press the extruder handle, remove the remaining filament before loading the new filament.
3) When the filament is loaded, please use a tweezers to clean the nozzle. Click on the button
in the lower left corner of Picture (10-8) and then it will enter printing information interface.
If the “Filament” shows green, which indicates resuming printing. You can click the left
To Next Page
Loading...
