Geeetech Rostock 301 Building Instruction

www.geeetech.com
Page 56
ShenZhen GETECH CO.,LTD
Mount extruder 1(E1) and extruder 2(E2)
Extruder 1 and Extruder 2 are much easier to be assembled. You can follow the above
steps except that there are no wires for the hotend, so you just need to connect the
motor wire and the fan wire.
You can finish the extruder assembly first and then mount them on the top plate.

Geeetech Rostock 301 Specifications

General

Brand	Geeetech
Model	Rostock 301
Category	3D Printers
Language	English