917334/BP0310 43
1. Using a jack or hoist, raise the front of the loader until its weight no longer
rests on the front blocks.
2. Carefully remove the blocking under
the front of the loader.
3. Slowly lower the loader until the front
tires are resting on the ground.
4. Repeat Steps 1 through 3 for the rear
of the loader. When the procedure is
finished, all four tires will be on the
ground and the blocks removed from
under the loader.
Replacement Parts
Note: Part numbers may change. Your Gehl dealer will always have the latest
part numbers.
Adjustments
Control Handles
The control handles do not require routine adjustment. Refer to the Service
Manual for the initial setup procedure.
Fuel Sender
The fuel sender, located in the fuel tank, sends a signal to the fuel gauge indi-
cating the amount of fuel left in the fuel tank.
Check the fuel sender periodically to ensure that the mounting screws are tight
and that there is no fuel seepage around the gasket. If replacement is required,
apply an RTV or gasket sealant around the gasket when restoring the fuel sender.
Part Description Gehl Part No.
Air Cleaner Element, Primary 188814
Air Cleaner Element, Secondary 188817
Hydraulic Oil Filter Element 074830
Engine Oil Filter Element 137500
Fuel Filter Cartridge 182130
Figure 25 Blocked Loader
To Next Page
Loading...
