44 917334/BP0310
Engine Speed Control
The throttle cable does not require routine adjustment. Refer to the Service
Manual for the initial setup procedure.
Besides throttle cable adjustment, the throttle lever friction pad pressure can be
readjusted if the throttle lever does not hold its position. Belleville washers and a
lock nut on the throttle lever are used for making this adjustment.
Drive Chains
The drive chains do not require routine adjustment. Refer to the Service Manual
for the initial setup procedure.
Lubrication
Listed below are the locations, temperature ranges and types of recommended
lubricants to be used when servicing this machine. Refer to the separate engine
manual for more information regarding recommended engine lubricants, quanti-
ties required and grades.
Refer to the following figure for grease fitting locations. Wipe dirt from the fit-
tings before greasing them to prevent contamination. Replace any missing or
damaged fittings. To minimize dirt build-up, avoid excessive greasing.
Hydraulic System
Use Mobil DTE 15M or equivalent that contains anti-rust,
anti-foam and anti-oxidation additives, and conforms to ISO VG46.
Capacity: 8 U.S. gallons (30,0 liters)
Chaincases
Use SAE15W-40 motor oil.
Capacity (each side):
8 U.S. quarts (7,6 liters)
Grease Fittings Use lithium based grease
Engine
Below 32°F (0°C) – Use SAE Grade* 10 or 10W-30
Above 32°F (0°C) – Use SAE Grade* 15W-40
*Service Classification: API - CH-4/CI-4
Capacity: 3-cylinder: 7.6 U.S. quarts (7,2 liters)
4-cylinder: 9.0 U.S. quarts (8,6 liters)
To Next Page
Loading...
