GEISMAR MPR-M - Transport - Storage

Chap. 1 — page 3
L.GEISMAR Company – Prohibited Reproduction©
HYDRAULIC RAIL THREADER H90461 / NO 10055
TYPE MPR – M
1 – 3 – 1 Transport – Storage
Handle carefully, to avoid the shocks, to use the suitable means.
Respect the instructions of storage if they exist, not to pile up in particular if there is risk
of deformation. Not to store in an abnormal position, to envisage chocks at the time of
transport.
Protect from the external corrosion and aggressions.
I
MPLEMENTATION/MAINTENANCE/INTERVENTIONS.
Make a program of inspection and to record all maintenances.
Replace any deteriorated or worn element.
Never not to modify the material without study and authorization of the manufacturer.
Work of maintenance must be completed by qualified personnel controlling the safety
requirements corresponding to the operations to carry out.
F
OLLOWING NONA PROLONGED USE OR AT THE TIME OF A PERIODIC CONTROL.
If a deformation or an abnormal wear is noted, the parts must be replaced.
Check the tightening and connections of the fasteners.
I
N PHASE OF WORK.
Know the working area and its characteristics, not to admit there that personnel
necessary to the operations.
Respect the general and particular conditions of safety, applicable to the working area
and to keep a constant sedentary vigilance during all the phases of the operations.
Know plans of intervention in the event of incident or accident and instructions of
prevention to be carried out during different the operates.
Never not to use an apparatus in bad condition, (wear, deformation...).
In the case of an abnormal behavior, to warn the qualified people.
Not to cause brutal contacts on the apparatus.
Never not to use the equipment for the transport of people.
Never not to neutralize the limitation or safety devices.
Check that nobody is in the zone of evolution of the material.
Station the material on a way not presenting a slope.
The lanes must have a sufficient gauge.
The lanes must be in a sufficient state to allow the evolution of the material without
risks.
Always use the material except by advancing special regulations of use.
I
MPORTANT!
These operation and safety instructions shall never be in conflict with official
regulations in force in the User Country. The person in charge of the equipment
operation shall check that these instructions match local regulations.
In addition, the person in charge of Customer safety shall add any other provision, as
required to improve information of personnel.