X
GEM-P9600 Programming Instructions
L
NAPCO Security Systems
WI777D 08/00
!
Page 54
⇐
!
1. Select the desired
zone option.
ZONE OPTIONS
50ms Loop Response
10ms Loop Response
Priority
Priority with Bypass
Auto-Bypass
!
2. Enable desired options
for each zone by drawing a
circle " around its
corresponding binary data
value.
NOTE:
No circle = feature disabled.
4821
Draw Circle
ZN04 ZN03 ZN02 ZN01
!
3. Search table below
for data entry.
!
4. Enter data in address
locations (left and right digits).
NOTE:
Dark shaded data value box
shows option not available.
ADDRESS LOCATION
LADDRR
blank (•) 1200 1
NOTE:
See Direct Address
Programming Example on
page 19.
4821
DIGIT VALUE DATA ENTRY
Blank (
.
)
4821
1
4821
2
8124
3
4821
4
5
4821
4821
6
4821
7
421
DIGIT VALUE DATA ENTRY
8
421
9
421
0
124
B
4 21
C
D
4 21
4 2 1
E
4 2 1
F
8
8
8
8
8
8
8
8
NOTES: (A) 50ms & 20 ms Loop Response only available for zones 1-8.
(B) 2-wire Smoke Detectors only available for zones 1-8.
(C) If Fire Alarm Verification is selected, then Fire must also be selected.
DEFAULTS: The zone options indicated are automatically set after exiting the Easy Menu Driven Mode.
!
Priority, Selective Bypass, Alarm Output, Auto Reset, Swinger Shutdown , Zone Area 1 and Zone Area 2 are enabled for the total number
of zones entered in
“AREA 1 # ZONES = 08” and “AREA 2 # ZONES = 00”
.
!
Alarm Telco 1 is enabled for the zones if [YES] is entered for “
REPORT ALL ZONES TO CENTRAL ZONES? Y/N
”.
!
Entry/Exit 1 and Chime are enabled for zone numbers entered in
“EXIT / ENTRY ZONES ”
.
!
Exit/Entry Follower and Interior Bypass are enabled for zone numbers entered in
“INTERIOR ZONES”
.
!
Fire, Pulse Alarm Output and Fire Verification is enabled for the zone numbers entered in
“FIRE ZONES”
.
!
2-Wire Smoke Detector is enabled for zone numbers entered in
“2 WIRE FIRE ZONES”
.
Note: See “Number of Zones &
Keypads per Area” in Easy
Menu Driven program Mode.
ZONE OPTIONS / ZONES 1-96 (ADDRESS 1200-2386)
Zone Options / Zones 1-96
To Next Page
Loading...
Need help?
General
