Gemu 1235 - General Information and Safety; Document Symbols and Terms; Warning Note Interpretation

www.gemu-group.com30 / 56GEMÜ 1235 / 1236
24V, 3S, 4S
1 General information
1 General information
1.1 Information
- The descriptions and instructions apply to the standard versions. For special versions not described in this document the ba-
sic information contained herein applies in combination with any additional special documentation.
- Correct installation, operation, maintenance and repair work ensure faultless operation of the product.
- Should there be any doubts or misunderstandings, the German version is the authoritative document.
- Contact us at the address on the last page for staff training information.
1.2 Symbols used
The following symbols are used in this document:
Symbol Meaning
Tasks to be performed
Response(s) to tasks
– Lists
The following LED symbols are used in the documentation:
Symbol LED conditions
Off
Lit (on)
Flashing
1.3 Definition of terms
Speed-
AP
function
Speed Assembly and Programming, a particularly
user-friendly commissioning function for fast mounting, automated setting and initialization of GEMÜ products. Dependent on
type, activation uses an external impulse signal or existing precautions on the device (magnetic or housing switch). Changeover
to normal operating mode takes place automatically after successful completion.
1.4 Warning notes
Wherever possible, warning notes are organised according to the following scheme:
SIGNAL WORD
Type and source of the danger
Possible
symbol for the
specific
danger
Possible consequences of non-observance.
Measures for avoiding danger.
Warning notes are always marked with a signal word and sometimes also with a symbol for the specific danger.
The following signal words and danger levels are used:
DANGER
Imminent danger!
▶ Non-observance can cause death or severe injury.
WARNING
Potentially dangerous situation!
▶ Non-observance can cause death or severe injury.