Gen2wave RP1100 - Charge Spare Batteries; Charging Temperature Guidelines; Power On RP1100; Calibrate Touch Screen

RP1100 User‟s Manual
17
Charging Spare Batteries
See Accessories for information on using accessories to change spare batteries.
Charging Temperature
Charge batteries in temperatures from 0°C to 40°C (32°F to 104°F). Note that charging is intelligently
controlled by the RP1100.
To accomplish this, for small periods of time, the RP1100 or accessory alternately enables and disables
battery
charging to keep the battery at acceptable temperatures. The RP1100 or accessory indicates when charging
is disabled due to abnormal temperatures via its LED. See Table 1-1.
Powering On the RP1100
After inserting the battery or when turning the RP1100 on for the first time, the splash screen displays for
about a minute as the RP1100 boots, then the calibration window appears.
Calibrating the Screen
NOTE To calibrate the screen so the cursor on the touch screen aligns with the tip of the stylus:
Remove the stylus from its holder on the side of the RP1100.
Carefully press and briefly hold the tip of stylus on the center of each target that appears on the
screen.
Repeat as the target moves around the screen, and then tap the screen to continue.
Checking the Battery Status
The easiest way to check the status of your battery is to look at the battery icon on the status bar of your
RP1100.
Battery Icon Status
Icon
Status
Battery is fully charged.
Battery has a medium charge. You should be able to work for several more hours
before changing batteries.
Battery is low. You need to charge or replace the battery soon.
Battery is critically low. You need to replace the battery now.
Battery is charging.