end of exit delay will be notified immedi-
ately
disabled – alarm from a zone violated at the
end of exit delay will be notified when the
zone will be restored and violated again (de-
fault).
7. Tamper on 10 wrong codes
enabled – after 10 attempts of entering
wrong code on the keypad, the keypad will
be locked for 60s and tamper signal will be
notified,
disabled – after 10 attempts of entering
wrong code on the keypad, the keypad will
be locked for 60s without tamper signal be-
ing notified (default).
8. Check after exit delay
enabled – if there will be any fault or zone
open after exit delay, the system will not
arm (EN50131),
disabled – the system will arm after exit de-
lay regardless of any faults and/or open
zones (default).
139. RTC clock synchronization
Selects RTC synchronization mode:
1 Manual RTC set without automatic DST,
2 Manual RTC set with automatic DST,
3 Auto-set using GSM network time (default).
The availability of automatic GSM network time
synchronization depends on GSM operators' infra-
To Next Page
Loading...