37
Protocol:
Two options of NTP or Time are available for your selection to
link with the Time Server. The default setting is NTP.
TimeZone:
The system administrator must select the time zone for the region.
Please refer to the appendix for the time zone selection table.
To set the Date Time manually, select “Set Manually” and the
system administrator must enter the Date and Time in the
respective field manually.
Note:
When you select Set Manually, every time when the IPCam
SECURE300 is powered off and on, you must re-enter the details
once again due to time lost.
Save/Cancel:
After making sure all settings in the DateTime are correct, click
the “Save” button to store the settings for the IPCam
SECURE300. You can alternatively click the “Cancel” button to
restore all settings to the values last saved to or retrieved from the
IPCam SECURE300.
To Next Page
Loading...