Operator Manual
Installation 2.3 © Genmega 2012
Step 4
Remove the cash cassette from its packing box (removable cassette dispensers only). Fill the
cassette or cash drawer with the appropriate amount of notes, and carefully place it in the Cash
Dispensing Unit. Place the appropriate denomination label on the front of the cassette. See page
4.9 for instruction.
Step 5
Before closing the vault, thoroughly test the combination lock by locking and unlocking the lock
several times. It is much easier to diagnose potential lock problems before shutting the door.
Step 6
Open the top of the ATM. Place the receipt paper in the Receipt Printer. The paper prints only
on one side (shiny side) always check the roll when you install paper. Place the roll so that the
coated side (shiny side) will be facing up. See page 4.12 for paper loading instruction.
Step 7
Connect the Power cable and the telephone cable to the appropriate outlets on the wall. Verify
that the AC power outlet is grounded (3 prong plug).
If you are installing an optional topper sign, install the power cord through the top housing and
plug the topper into the open connector (white) located on the back of the slide tray. Make sure
the cable has enough slack to allow the slide tray to open completely.
Step 8
Turn the power on and verify that all systems are operational. If any part on the system or its
programming is not operational, an error code will be displayed along with instructions. If the error
cannot be corrected, please contact your distributor for help. If no error code is displayed, check
the Error Summary.
To Next Page
Loading...
Need help?
General