Operator Manual
Programming 3.35 © Genmega 2011
3.6 TCP/IP SETUP
TCP/IP Setup is done in several menus. First you need to specify TCPIP from the
Communications Menu: [See page 3.27] Check with your processor for which protocol settings
they are expecting.
To change, go to:
Operator Function Menu Æ Customer Setup Æ Change Processor Æ Communication
Change this value to SSL PassThrough (or other depending on processor)
Once you change from Modem, to one of the TCP/IP settings, several other menus change to
support various network functions.
For Example:
Operator Function Menu Æ Host Setup Æ Host IP and Port #
Here you will set the Host Processor IP (or URL) address and port. For some processors an IP
address (example = 121.212.1.21) is used and for others you’ll enter a URL address (example =
trans.mybank.processor).
In addition to the address, there will also be a port setting (example = 6543)
Configuration Schedule allows you to force the ATM to update configuration with the host upon
boot up. You might use this command if the terminal gets consistent Key Errors and you want to
force download of a new working key.
To Next Page
Loading...
Need help?
General