Operator Manual
Programming 3.25 © Genmega 2011
3.4.2 BIN LISTS
BIN numbers are card numbers that you have preset with your processor to not be surcharged.
You must set this up with your processor, who will then give you numbers to enter in the list.
These numbers will reference cards that you wish to not be charged a surcharge for transactions.
The ATM will hold up to 60 numbers.
If you need more BIN numbers, there is a file that can be created to load several thousand more
numbers. Contact technical support for instructions.
Step 1
To enter the BIN numbers select BIN List from the
Customer Setup menu. The list can hold 2 banks
of 30 numbers for a total of 60. Bank 0 and Bank
1. Press the OTHER button to switch between
the banks.
Step 2
To add a number, press ADD and input the BIN
number with the keypad. To remove, press
REMOVE and type in the BIN number you wish to
delete from the list.
Press OTHER to switch between Bank 0 and
Bank 1.
Step 3
If you wish to view the contents of the BIN list, use the Print All Setup report. From the Operator
Function Menu, go to Reports, then Print All Setup. Any numbers added to the BIN list will be
visible from this report. NOTE:
Numbers loaded via the extra BIN file will not display on the Print
Setup or any other report.
To Next Page
Loading...
Need help?
General