Operator Manual
Programming 3.5 © Genmega 2011
3.2 HOST SETUP
The Host Setup menu provides access to the parameters necessary to connect the ATM to the
processor. Master Password is required to access most of these options; however Service
password allows basic access for troubleshooting purposes.
3.2.1 KEY MANAGEMENT
Access to Key Management requires entering a “Secure Mode” which engages additional security
measures (per VISA specification) to prevent Master Key tampering. Make note of these
changes as it does affect how keys are entered.
Entering Key Management requires two 6-digit passwords. By default these will be “000000” for
part #1 and “000000” for part #2.
If a mistake is made entering the “Secure Mode” password, you will be prompted to wait 30
seconds to reattempt.
NOTE: In compliance with PCI specifications, you must change the Secure Mode Passwords
from default before any Master Keys can be entered. After changing the Secure Mode
Passwords, you must exit completely from the Operator Menu, and reboot the machine. After this
step, you can enter Master Keys.
To Next Page
Loading...
Need help?
General