Operator Manual
Customer Transactions 6.9 © Genmega 2011
6.6 ERROR RECOVERY
If an error occurs the following screen will be displayed.
Step 1
To access the Operator Function menu, press the
following keys in order <Cancel>, then <Clear>, then
<Enter> then 1, then 2, then 3.
Step 2
Verify the Error that has occurred through the
“ERROR CODE” of the “REPORT MENU” in the
“OPERATOR FUNCTION,” menu and perform the
corrective action, then press the “DEVICE
INITIALIZE” screen key.
If the Error is not corrected after resetting, contact
your service personnel.
To Next Page
Loading...