Operator Manual
Programming 3.7 © Genmega 2011
CHANGE PASSWORD
This allows you to set each part of the “Secure Mode” Password. As with the other passwords
used in the G2500™, each must be a 6 digit number. If you change the password and cannot
remember it, you must clear RAM on the pin pad to reset.
NOTE:
In compliance with PCI specifications, you must change the Secure Mode Passwords
from default before any Master Keys can be entered. After changing the Secure Mode
Passwords, you must exit completely from the Operator Menu, and reboot the machine. After this
step, you can enter Master Keys
.
Entering Master Keys:
Use the chart below for entering Master Keys from the main pin pad.
Master Keys (or Key Management) cannot be entered from the optional Rear Service Panel.
Please see Appendix for specific Master Key instructions.
NOTE: The keypad above is EPP-B1 PCI / Interac certified EPP Device.
Previous models of Genmega EPP (PCI Only) had the Enter and Cancel keys reversed from what
is displayed above. If entering keys on the PCI only keypad, remember that the Enter key is
always F and the Cancel key is always D.
To Next Page
Loading...
Need help?
General