Operator Manual
Programming 3.18 © Genmega 2011
To change a password, press the button for the appropriate password. You will be prompted to
enter the new password and then enter it a second time to verify. If you forget your password
please contact your dealer or distributor for service.
NOTE: All passwords MUST be 6 digits. If you use a password that is less than 6 digits, the
passwords may default back to factory if the machine is power cycled. If your customer wants a 4
or 5 digit password, add zeros to the end to make it 6 digits.
WARNING: The ATM will NOT go into service with the default master password. You must
change the master password from default! If you attempt to go in service with the default master
password, you will receive a F0016 Error, which will notify you that the master password has not
been changed.
It is critical that you do not set the same password for each of the three levels. If you duplicate the
password, the lower level permissions will be the default.
For example, if the Operator Password is set to 123456 and you also set the Master Password to
123456, then when you log in with that password, you’ll only have access to Operator level
commands. In this example, you’d have to change the Operator Password to something else,
and then 123456 would then allow you to log in as Master. If you forget the passwords, you’ll
need to reload the AP software to reset.
To Next Page
Loading...
Need help?
General