TECHNICAL SUPPORT: 1.800.283.5936 (USA) OR 1.801.974.3760
3
G-Ware software must operate on computer equipment that meets the
following minimum requirements:
Operational Requirements
Operating system: Windows 95 OSR 2.1/98/2000/NT
PC Hardware Requirements
Pentium 200MHz
20MB free hard drive space
PCI or AGP video card with 2MB RAM (minimum); 4MB RAM recom-
mended
Video monitor with 800x600 video resolution, 256 colors, and 16-bit
color depth (minimum); 1024x768 video resolution recommended
RS-232 COM port
CD-ROM drive
Mouse
Creating Floppy Disk Copies
Depending upon the computer equipment you have available, you
might need to install G-Ware software from floppy disks rather than the
included CD. To do this, a Disk Copy program is provided in G-Ware that
allows you to transfer G-Ware to floppy disks. You will need a PC with a
CD-ROM drive to make the transfer. After installing G-Ware on the CD-
ROM-equipped computer (see Installation Procedure on page 18), you
can access the Disk Copy program in the following way:
After installing G-Ware, go to the Windows Start menu, select
Programs, then Gentner G-Ware, then Create Install Floppy Disks.
Follow the on-screen prompts to complete creation of the floppy disks.
XAP 800 G-Ware
Software
Pre-Installation
Information
G-WARE SOFTWARE • INSTALLATION
17
To Next Page