GeoMax Zone60 DG - Page 38

007622_001
Display brightness screen
With this setting, you can change the display brightness.
Use the Up and Down arrow buttons to adjust the brightness as
desired.
007623_001
007624_001
Save beam masking
screens
Normally, the beam masking setting is disabled every time you
turn off the Zone60 DG.
If you prefer to save the beam masking settings for usage on the
following day, you can enable the saving of the beam masking
setting:
•
Save: The beam masking settings are saved at power off.
•
Do not save: The beam masking settings are disabled at
power off.
Display brightness
Save beam masking at
power off
38 Zone60 DG Menu