Connect the sample tube, if relevant, from the sample point to the inlet port of the instrument,
ensuring the filter is seated correctly.
If auto-logging is required select the ID codes.
If auto-logging is not required, press the pump key to draw a sample, stop the pump and press
the soft-key ‘Store’ to store the reading. The operator will then be prompted to enter or select
ID codes. Select ID codes and press the ‘Accept’ button to confirm. A message will display
confirming that the reading has been stored.
The instrument automatically takes the operator back to the ‘Main Read Screen’ ready to take
another reading.
To Next Page
Loading...
