16
2.2.2 Keypad (GV-RK1352 Only)
When accessing an entry using GV-RK1352, you can enter the door’s PIN code on the
keypad or present the card and then enter the card’s PIN code on the keypad to be granted
access. The access mode is defined on GV-ASManager.
1. 0~9 Number Keys: Press the number keys to enter the PIN code.
2. # Key: Press the # key to confirm the PIN code.
3. ﹡Key: Press the ﹡key to cancel the PIN code.
IMPORTANT: For Card and PIN Code mode, users need to enter the card’s PIN on the
keypad and then present the card for access granted.
2.2.3 LED Indicator and Beeper
In standby mode, the LED is blue. When a card is read, the LED flashes green and the
beeper beeps once.
The reader comes with external control wires for Green LED, Red LED and Beeper. You can
connect these control wires to GV-AS Controller to change the default settings of the LED
and Beeper. For details on how to configure the settings, see 2.6 Changing the Settings of
Beeper and LED later in this installation guide.
Note:
1. The following controllers support LED and beeper wiring: GV-AS210 / 2110 / 2120 /
410 / 4110 / 810 / 8110, and GV-AS1620.
2. The LED indicator and beeper functions are currently unavailable for GV-RK1352 when
it is accessed by the built-in keypad.
To Next Page
Loading...
Need help?
General
