GeoVision GV-Reader1251 User Manual

GV-RK1352 / R1352 / DFR1352
29
2
2.7 Setting UID or GID on GV-R/RK/DFR Config AP
By default, the readers read the UID (unique identifier) on ID cards or key fobs. Using GV-
R/RK/DFR Config AP, you can set the GV-RK1352 / R1352 / DFR1352 to read GID
(GeoVision ID) on GV-AS ID Cards / Key Fobs instead.
Note:
 For how to install the Config AP and how to identify the COM port of the reader, see
2.4 Installing GV-R/RK/DFR Config AP and 2.5.1 Defining the ID Number and Setting
the Reader to Slave.
 GID ID format is only supported in GV-RK1352 / GV-R1352 / GV-DFR1352 (Rev. B)
V1.2 or later.
 If you are using third-party cards or key fobs, you must set the reader to read UID.
1. Run GV-R/RK/DFR Config AP.
2. Select the COM port that is connected to the reader and click Open COM. The red
square next to the COM port box should change to blue to indicate the COM port is
correct.
3. To set the reader to read GID, select Only Read GID.

GeoVision GV-Reader1251 Specifications

General

Brand	GeoVision
Model	GV-Reader1251
Category	Card Reader
Language	English