35
Using the RFID Reader (Optional)
Select models have an HF RFID reader. The reader can read data from HF
(High Frequency) RFID (Radio Frequency Identification) tags.
The RFID reader is enabled by default. To enable or disable the reader, run
the BIOS Setup program and select Advanced Device Configuration
RFID Card Reader. (See Chapter 5 for information on BIOS Setup.)
For optimal results when reading an RFID tag, have the tag face the antenna
in the same orientation as indicated by the icon on the exterior of the
computer. The icon indicates where the RFID antenna is located.
NOTE:
When not using an RFID card, do not leave it within or near the antenna
area.
For enhanced applications and customization of the module, contact
your authorized Getac dealer.
To Next Page
Loading...
