43
Replacing the Battery Pack
CAUTION:
There is danger of explosion if the battery is incorrectly replaced. Replace
the battery only with the computer manufacturer’s optional battery
packs. Discard used batteries according to the dealer’s instructions.
Do not attempt to disassemble the battery pack.
A battery pack can get hot due to long working hours. Do not touch a
hot battery pack with bare hands. After removing a battery pack, put it
in a well-ventilated area.
NOTE:
You can hot swap one battery pack while another one is supplying the
power. The appropriate temperature range for hot swapping the battery
pack is between -21°C (-5.8 °F) and 45 °C (113 °F).
The illustrations show B360 as the example. The removal and installation
method for B360 Pro is the same.
1. Skip this step if you are hot swapping the battery pack.
Turn off the computer and disconnect the AC adapter. After turning off
the computer, allow a cool-down time of at least 5 minutes before
removing the battery pack.
2. Carefully place the computer upside down.
3. Locate the battery pack you want to remove. (See “Bottom Components”
in Chapter 1 for battery pack locations.)
4. Slide the battery latch inwards (
) and then toward the unlocked
position ( ) (
). The battery pack will slightly pop up.
To Next Page
Loading...
