28 -
OPERATION
Alarms in standby mode
An alarm from an idle sterilizer prevents it being started.
•
Call a technician.
Alarms during a cycle / Avanti
A fault occurring during a cycle stops the cycle. All valves close in
order to stabilize the conditions in the chamber.
Automatic quick stop of the cycle
If the load contains liquids, choosing the wrong program
may endanger personnel and equipment.
An alarm signal sounds and the relevant error code is
displayed on the cycle screen. The cycle screen’s
background turns red and the Alarm indicator is shown.
•
Press
Silent alarm signal
to turn off the alarm signal.
•
To show detailed alarm information press
Alarm
.
The most recent alarm is displayed at the top of the list.
Press the desired alarm to get detailed information
about the alarm.
•
After acknowledging the alarm, the following
alternatives are available:
·
Automatic quick stop of the cycle
·
Call a technician.
To quick stop:
•
Depending on how the cycle is set, the cycle stops
automatically or the cycle stops until the user presses
Start
.
•
The Finished Cycle indicator lights up red after the
cycle is finished.
•
Acknowledge the alarm by pressing
More
and then
Ack.
To Next Page
Loading...
