www.gisma-connectors.de9Cabling Instructions series 10+22 Revision F - 11/2018
CABLING INSTRUCTIONS - SERIES 10 + 22
Bestellnummer
ordering number
for optimal adhesion between moulding compound and metal,
zur besseren Haftung zwischen Vergussmasse und Metall,
5. Primer 3 (30 ml)
5. Primer 3 (30 ml)
Ablüftze über 5 °Cit min. 10 Minuten max. 24 Stunden bei
cure-tim t over 5° Ce min. 10 minutes max. 24 hours a
speziell für Aramid-Konfektionierungen
6. Hartvergussmasse 90 g
Aushärtungszeit ca. 3 Stunden bei 20 °C
specially for aramid terminations
cure-time approx. 3 hours at 20 °C
6. hard moulding compound 90 g
manufacturer: WOLF Kabeltechnik GmbH
part no.: EP 6476 / 10 B40251
Artikel-Nr.: EP 6476 / 10 B40251
Hersteller: WOLF Kabeltechnik GmbH
part no.: RER 2074 / RER 2188
manufacturer: ELEKTROLUBE
7. hard moulding compound 500 g
cure-time approx. 24 hours at 20 °C
Hersteller: ELEKTROLUBE
7. Hartvergussmasse 500 g
Aushärtungszeit ca. 24 Stunden bei 20 °C
for series 10 size 7+71
Artikel-Nr.: RER 2074 / RER 2188
für Baureihe 10 Größe 7+71
Aushärtungszeit ca. 24 Stunden bei 25 °C
8. hard moulding compound 250 g
for series 10 size 5 + 6 and series 22 size 5 - 7
8. Hartvergussmasse 250 g
für Baureihe 10 Größe 5 + 6 und Baureihe 22 Größe 5 - 7
cure-time approx. 24 hours at 25 °C
for the outer endbell mounting
9. PUR moulding (250 g)
Aushärtungszeit ca. 36-48 Stunden bei 25 °C
9. PUR-Vergussmasse (250 g)
für den äußeren Endgehäuseverguss
cure-time approx. 36-48 hours at 25 °C
BENÖTIGTE WERKZEUGE UND HILFSMITTEL
Vergussmaterial
NECESSARY TOOLS AND AUXILIARIES
moulding material
ATTENTION: Item 5-8 is recommended for the
connection area of all moulding endbells!
ACHTUNG: Pos. 5-8 wird für den Anschlussbereich aller
Vergussendgehäuse empfohlen!